Every device at some point in time may need to be reset to the default settings. You may need to reset the Linksys extender as well.  Maybe it needs a fresh start or you forgot the admin password and hence can’t go past the Linksys extender login page. Another potential cause is that your extender is troubling you and is not getting fixed using any troubleshooting hack. But if you are failing to reset your extender, then it is really troublesome. We can help you reset your extender by eliminating the hindrance that is blocking the reset process.

Linksys Extender Can’t Be Reset? Try This!

Are you Using the Right Steps?

May be the steps that you are following to reset your Linksys wireless extender are not correct. Or perhaps you are committing a mistake while executing the steps. We have highlighted the correct reset instructions ahead. Please refer to them and make sure that you are resetting your extender correctly:

1. Remove the Ethernet cable connecting the extender to the router.
2. Next, ensure that the extender is fully powered on.
3. Locate the Reset button on the extender.
4. You will find the button inside a hole labeled Reset or Factory Reset.
5. Use a sharp and pointed object like a paper clip and push the button for some 15 seconds.
6. Once you release the button, your Linksys extender will be reset and running on the default settings.

Is the Power Supply to the Extnder Optimum?

In the above-given point ping monitor, we have mentioned that the extender should be fully powered up before you reset it. This is an essential step. You should check that there is no fault in the power socket or the power adapter of the Linksys extender that may be causing the power supply to fluctuate.

You can use an alternative socket to plug in the extender and make sure the power cable is not loose. If needed, use a UPS (Uninterrupted Power Supply).

Have You Pressed the Reset Button for Enough Time?

You ought to push and hold the Reset button for some time. In case you are releasing the button too soon then the extender won’t reset. Perhaps this is the reason why you are not able to get your extender running on the factory values.

We recommend you try the Linksys extender reset process once again. This time you should hold the button for a longer period. You can press and hold the button for more than 15 seconds as we have suggested to you in the instructions.

Can You Log In? Try Web Interface to Reset Extender

In case the Reset button is not letting you reset your Linksys wireless range extender then you also have the option of using the web interface to get the process done. But you should be able to log in for that. In case you can access the  Linksys login page then use the steps given below:

1. Log in to your Linksys extender by using the IP address or the login URL.
2. As soon as you log in, go to Settings.
3. Select Factory Defaults under the Administration option.
4. Click on the Restore Factory Defaults button to reset your extender.

Extender Not Yet Reset? Perform a Reboot

If you fail to reset your Linksys extender even after all this, then perform a simple reboot process. Power off the extender and power it on only after giving a gap of a minimum of 5 minutes. Now try the reset process.

Your extender will be reset. Now access the http //extender.linksys.com setup page and execute the setup instructions.

Verdict

We anticipate that the issue that you were struggling with has been resolved and left your side. Now that you have set up your Linksys extender, you can again begin enjoying lag-free internet across your home using it.