VICTONY AC1200 Extender Setup Quick Guide

We'll examine the Victony wifi AC1200 Extender Setup from every angle in this article. We'll start by looking at the Victony dual-band AC1200 wireless extender, which has four external antennas and provides superb Wi-Fi coverage at home or at work.

Due to the quick installation and setup, you may start browsing the internet in only a few minutes. The majority of expander products on the market are compatible with it because it supports IEEe802.11a/ac/n/g/b standards. Since it is a plug-in and supports WPS, it launches rapidly.

victony AC1200 wifi extender via Web Browser

• Start by positioning the extender in the router's center and in the empty space.

• Then make sure that at least 50% of the signals are being sent to the extension unit by your network.

• After turning it on, put the Victony AC1200 extender in "continuous/extender mode."

• Hold on for a short while until the power LED turns a bright green color.

• Next, connect to Victony's wifi name on any of your computers on your phone, tablet, or portfolio by opening the Wi-Fi settings on each of them. Either Wireless-N or Victony Extender will be used.

• You will initially seem as a password-protected open network.

• Once you've finished connecting, you'll hear the message "No internet."

• Open the browser on your device, choose ap.setup, and then enter the "admin" login and password. Everything is really small.

• Select the network you wish to expand next, give it a name, and then confirm it by entering its password.

• After all changes have been done, it will reboot for roughly 60 seconds before your PCs may be added.
• Your Wi-Fi list should display the Victony AC1200 repeater network, which you should connect your devices to (SSID EXT).

Note:- if you need any help regarding you wifi extender so contact our technician or visit the official website that is ap setup.

How can i setup my VICTONY AC1200 Extender via wps button

• Starting in the same room, connect the Victony AC1200 extender configuration via WPS.
• After the power LED of the AC1200 has stabilized for a few seconds, press and hold the WPS button for two seconds.
• The LED lights on both devices should begin to blink within 10 to 15 seconds, signifying a successful setup.
• For the Victony wa1200, WPS LEDs would therefore be solid green.
• If this doesn't work, keep in mind to reset the extender and try again.
• The extender can then be removed and put somewhere inside the router's coverage, for example.
• The same password you use for your Wi-Fi extender will show up on the SSID EXT List.

Access Point using a Victony AC1200 extender

Access point mode is unquestionably faster than range extender mode. You should use or install an Ethernet cable that is 20 to 30 feet long in your walls. Before we start, make sure the devices are on and in Access Point mode.

• Set up wa1200 as the primary access point.

• Connect your AC1200 first to the location where you want to utilize it.

• From the LAN port on your repeater, attach an Ethernet cable to the LAN extender connector.

• If you connect your Victony Extender to your phone, laptop, or tablet, your name will appear on the Wi-Fi list.

• Launch a browser on the connected devices, and then type 192.168.10.1 into the address box.

• This launches the Victony AC1200 extension's configuration page. The login tab is now being highlighted. Enter "admin" as the username and the corresponding password. Everything is really small.

• After entering the credentials, choose the "entry point" from the setup wizard, and then click Next.

• A new access point's SSID, security, and password will now be required.

• It then resumes, enabling you to join your devices to the recently established network.